Material: tool steel
Size: (length x width x height) about 3.5 x 3 x 1cm/1.38 x 1.18 x 0.39in
Applicable scenes: used for grafting pruning cutting
Grafted high carbon steel blade
Cut diameter: about 1.5cm
Incision depth: U blade about 1cm
Minimum cut diameter: 0.5cm
Material: Tool steel
Handle material: PVC
Shape: V Type
Opening size: approx. 35mm/1.37''
Length: approx. 210mm/8.26''
Weight: approx. 520g
Blade length: approx. 20mm/0.78''
Trim diameter: approx. 15mm/0.59''
Materials: carbon steel, ABS and Aluminum
Cut grafting stocks diameter from 5mm/0.2'-1.4cm/0.55'
Trimming blades thickness: 3mm/0.12'
Phillips screwdriver with red handle
Size 27cm * 10cm/10.5inch * 3.9inch
Grafting Tape Width: 2cm/0.79'
Material: carbon steel, ABS and aluminium
Cut the grafted seedlings from 5mm to 1.4cm in diameter
Trimmer blade 3mm thickness
Cross screwdriver with red handle
Dimensions 27 cm * 10 cm / 10.5 inches * 3.9 inches
Graft adhesive bandwidth: 3cm/1.18'
(1 cm = 0.39 Inches)
Two additional blades
How to use:
Step 1: Place the graft in the grafting tool, press the handle to cut, and repeat this step to cut the stem of the donor plant. Be sure to cut slots in the factory.
Step 2: Slide the donor stem into the groove of the plant and match the cutting surface as much as possible. If stocks and donor factories are different in size, they can only be matched on one side.
Step 3: Put the sterile material at the joint and tie it with tape. The sterile material can prevent bacteria and climatic conditions.
Step 4: Use pruning pruning to cut useless branches from plants.
Step 5: The blade with 'V&U&Omega' blade and the blade at both ends can be cut. One blade can be used as two blades. There are six blades.
1. Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
2. Please allow slight measuring deviation due to manual measurement.